Bearing Puller
Automotive Tools
- Wheel Bearing Removal Tool
- Ball Joint Separator
- Brake Caliper Tool
- Oil Filter Wrench
- Coil Spring Compressor
- Injector Puller
- Bush Tool
- Altermator Puller Puller
- Engine Timing Tools
- Clutch Alignment Tool
- Engine Compression Tester
- Engine Repair Tools
- Injector Seat Cutter
- Mechanic Creeper
- Oil Drain Plug Key Tool
- Fluid Oil Extractor
- Brake Bleeder
- Fuel Tank Wrench
- Wiper Arm Puller
- Motorcycle Chain Breaker
Truck Repair Tools
Mechanic Tools
Plastic Auto Tools
Don't stop when the truck stops. These maintenance can't be stopped. Tanaka transmission repair tool
Operate and use the transmission correctly and reasonably, and perform regular maintenance. DNT editor has extracted some maintenance methods from the Fast transmission repair tool manual for your reference:
1. Check the oil level position. The oil level should be flush with the lower edge of the oil level observation hole and should not be 5mm lower than the lower edge of the oil level observation hole. Too much oil filling will cause the transmission temperature to rise and oil leakage; too little oil filling will cause poor lubrication of parts, and in severe cases, a burning accident will occur.
2. Oil change cycle. The lubricant must be replaced when the new transmission travels 2000~5000km. The oil level and leakage of the lubricant should be checked every 10000km, and it should be replenished at any time. The lubricant should be replaced every 50000~80000km.
3. Working temperature. The temperature of the transmission during continuous operation shall not exceed 120℃, and the temperature shall not be lower than -40℃. When the working temperature exceeds 120℃, the lubricant will decompose and shorten the life of the transmission.
4. Working inclination angle When the working inclination angle of the transmission exceeds 12°, the lubrication may not be sufficient. A lubricating oil pump or cooling device can be installed to ensure good lubrication.In case of a failure, don't try any treatment to save some money, which may easily cause more serious failures. It is better to find a regular service station or repair shop, because there are special repair tools for gearbox repair. Take our Fast gearbox special repair tools as an example: Fast gearbox repair tools This set of Fast gearbox is specially designed and produced for Fast. It is made of international standard steel and processed with humanized design concepts. It has high strength and can be used twice as many times as ordinary steel without damage. This is the advantage of materials.
At present, there are many repair shops equipped with this set of Fast gearbox repair tools, and they are exported to other countries. If you are also interested in DNT's special repair tools for large vehicles, please contact us.
Are you looking for a reliable manufacturer of Automotive Tools&Hand Tools?
We can quickly provide customers with market analysis, technical support and customized services.
- Ningbo Dongning Tools Co.,Ltd
- Professional Chinese Tools manufacturer on hand tools& automotive tools
- Address
- No.6 Falan Rd,Hengjie Town,Ningbo City,Zhejiang,China
- Phone
- +86-574-87216625
- info@nbdntools.com
subscription